This card is very similar to the other robot card I made recently. Originally I was going to use a background stencil with some silver stencil paste... but after FIVE, yes, FIVE attempts, the stencil just would not cooperate. The stencil paste kept bleeding through and ruining the card base. The stencil also had a… Continue reading More Robot Fun
Category: Tips and Tricks
Easter Egg Shaker Card
I made this card with 4 separate shakers for each Easter egg. I followed some of the steps in this blog post when putting it together: https://hungryheffycrafts.com/2018/03/multi-shaker-easter-card-ft-heffy-doodle-honey-bunny-boo/ One tip in that blog post was to lay the top piece of your card down before adding the acetate, and then to inlay each colored Easter egg… Continue reading Easter Egg Shaker Card
Reveal Wheel + Selfie Frames
I just love how this card turned out! It has a nice clean look and it feels very substantial with the foam tape under the wheel. The acetate piece over the top gives that screen look even more and really puts it over the top! This card required some partial die cutting. (See below.) I… Continue reading Reveal Wheel + Selfie Frames
How to arrange stamps on a wavy banner
Here's a quick tip for how to arrange a stamp on a wavy banner so that it follows the curve of the banner: Start by laying your die-cut banner down face down. The side you will be stamping on should be touching your craft mat or surface. Next, place your acrylic block over your banner,… Continue reading How to arrange stamps on a wavy banner